LG G5500 Manual page 123

C. TX APC Test Frame
At this part, you can control transmit path of target phone.
Serving Freq. Setting (TCH)
You can set TCH of phone. The number means ARFCN of Traffic channel.
Beacon Freq. Setting (BCH)
You can set BCH of phone. The number means ARFCN of base station broadcasting channel.
Power Level Setting
First, you have to choose operating mode (GSM or DCS) according to TCH and BCH frequency
that you selected before. Then select the Level and adjust the DAC value. Level means GSM/DCS
output power level. Usable range is 5 to 19 for GSM, 0 to 15 for DCS. DAC value is a factor to
determine output power. Its variable range is 0 to 1023.
Uplink Normal Burst test
You can also control the traffic slot number be using by changing TCS value. Because GSM has
8-time slot, TCS value varies 0 to 7. Patten is to select data format that is transmitted. You can
send all data 0, or 1 or repeating of 1010. But it is good to you to using the default value because data
format doesn't affect to RF characteristics.
Test
Transmitting is started when you click this button. During Transmitting, label of Test button is changed
to Stop. If you want stop transmitting, click this button one more.
D. RF Parameter Download Frame
Saving epm file into Flash
When you have a epm file, contains calibrated data, and you want to download into target Flash,
check Flash and click File Download button. Then you can see RF parameters Save window.
Select epm file you want to save into Flash then click Open. During saving file into Flash, The
statement bar indicating download process is displayed under the RF Parameter Download frame.
As successfully ending download, information box will be appeared. Click Ok.
Saving Cal. Data to Flash
After Rx or Tx calibration, you can save the calibration results into Flash and epm file. Check Flash and
click Calib Save button. Then you can see RF parameters Save window. Write the file name and click
Save button.
-124-