Table of Contents
Advertisement
Installation
After checking the height, width and structure of the installation location while referring to the "Dimensional rela-
tionship diagram" in the "Standard installation dimensions" (pages 5-6) and "Dimensional relationship" in the Ap-
pendix, determine the appropriate positions for setting up the screen and installing the projector.
Setting up the screen
Set up the screen according to the specified method in a position which takes into account the projection distance
and angle and the type of screen being used.
Screws tightening torques
M4.........1.25 ± 0.2 N • m
z When tightening the screws, use a tool such as a torque screwdriver to tighten the screws to the specified tight-
ening torques. Do not use electric screwdrivers or impact screwdrivers.
Installing the bracket to the projector
Install the bracket to the projector (sold separately) by following the procedure below.
Adjustable foot
Adjustable foot
lock latch
Projector mount
bracket
Rubber cap
1 Place the projector upside down on the top of a
soft cloth.
2 Retract the adjustable foot.
z Press the adjustable foot lock latch and release
it at shortest length of the adjustable foot. Or
rotate the adjustable foot in clockwise to retract
it.
3 Remove the rubber cap on the bottom of the pro-
jector (one place).
Attention
z If the projector will be used for the desktop instead
of for the ceiling, the rubber cap will be necessary
to prevent burning. Save it for future use.
4 Secure the projector mount bracket to the bot-
tom of the projector using the 4 supplied captive
washer screws (M4 × 10) as illustrated on the
left.
ENGLISH - 7
Advertisement
Table of Contents
