Table of Contents
Advertisement
Hard Disk Format Utility,
Continued
Answer the questions on the screen. The first two questions are already completed if one disk was selected in STANDARD CMOS SETUP. Enter C or D in Disk
Drive and press <Enter>. If only one drive was selected in STANDARD CMOS SETUP, the cursor will be at Interleave.
The Disk Drive Type is read from CMOS RAM. The Interleave factor can be selected manually or determined by Auto Interleave.
The hard disk drive manufacturer usually provides a list of bad tracks. Enter these tracks. They will then be marked as bad to prevent data from being stored on
them.
The following screen is displayed after entering Y in Mark Bad Tracks, pressing <Enter>, and selecting add, delete, revise, or clear from the Bad Track Edit
Menu.
Advertisement
Table of Contents
