Table of Contents
Advertisement
Resetting the Pocket-PC
Cold starting and resetting factory default settings
If your Pocket PC stops working, and switching off and on with the End button and the soft reset is
unsuccessful, you can perform a cold start with your Pocket PC or reset it to the factory default settings.
Unsaved data will be lost. Only carry out a cold start and resetting
when the battery is fully charged.
► Slide off the battery cover from the Pocket PC.
► At the same time press and hold the End button (1) and press the tip of the
stylus pen into the soft reset opening (2).
► Release the end button as soon as a list of possible options is displayed on the screen.
► Select Skip if you would like to perform a normal cold start.
► To restore the Pocket PC to the factory defaults select Factory Defaults.
The selected option is performed.
It may take a few minutes for the factory defaults to be restored. At the end an acoustic
signal sounds. Please follow the further instructions on the display.
The data memory is deleted when the Pocket PC is restored to its factory
defaults. This means: You will lose all data (documents, additionally installed
programs, personal settings) that you haven't saved elsewhere. Always back up
your data on a regular basis (memory card, FSC Backup).
If you have set a password with FSC SecureLock then this password will remain.
20
1
A26391-K182-Z100-1-7619, edition 2
2
Advertisement
Table of Contents
