Sony SLS-1A Reference Manual page 6

For customers in the U.S.A. and Canada
Owner's Record
Record the serial number in the space provided below.
Refer to them whenever you call upon your Sony dealer.
Model No. SLS-1A
Serial No. __________________
The model and serial numbers are located on the
following:
• the rear of the unit
Do not install the product in a confined space, such as
a bookcase or built-in cabinet.
To reduce the risk of fire, do not cover the ventilation
opening of the unit with newspapers, tablecloths,
curtains, etc. Do not expose the unit to naked flame
sources (for example, lighted candles).
To reduce the risk of fire or electric shock, do not
expose this product to dripping or splashing, and do
not place objects filled with liquids, such as vases, on
the product.
The unit is not disconnected from the AC power source
(mains) as long as it is connected to the wall outlet,
even if the unit itself has been turned off.
Install the unit so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
This product (including accessories) has magnet(s)
which may interfere with pacemakers, programmable
shunt valves for hydrocephalus treatment, or other
medical devices. Do not place this product close to
persons who use such medical devices. Consult your
doctor before using this product if you use any such
medical device.
The validity of the CE marking is restricted to only
those countries/regions where it is legally enforced,
mainly in the EEA (European Economic Area) countries/
regions and Switzerland.
The validity of the UKCA marking is restricted to only
those countries/regions where it is legally enforced,
mainly in the UK.
CAUTION
Risk of fire or electric shock.
The power supply terminal is for the SLS-1A only.
Up to two SLS-1A units can be supplied with power
from the unit to which the power cord is connected. Do
not supply power to three or more units.
2
GB
For customers in the U.S.A.
NOTE:
This unit has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in
a residential installation. This unit generates, uses, and
can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this unit does
cause harmful interference to radio or television
reception, which can be determined by turning the unit
off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the unit and
receiver.
• Connect the unit into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Supplier's Declaration of Conformity
Trade Name: SONY
Model: SLS-1A
Responsible Party: Sony Electronics Inc.
Address: 16535 Via Esprillo, San Diego,
CA 92127 U.S.A.
Telephone Number: 858-942-2230
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference
received, including interference that may cause
undesired operation.
You are cautioned that any changes or modifications
not expressly approved in this manual could void your
authority to operate this unit.
POWER OUTPUT AND TOTAL HARMONIC DISTORTION:
With 6 Ω loads, both channels driven, from 200 -
20 000 Hz; rated 10 W per channel minimum RMS
power, with no more than 1% total harmonic distortion
from 250 mW to rated output.