Advertisement
12
This system is designed to permit the use of already
prepared presentations without requiring the reorientation
of slides.
For those setting up a new tray and/or presentation:
1. Arrange the slides in the order that they should appear
in the presentation. Arrange them so that they are
upright and reading correctly from left to right.
2. Rotate each slide to turn the image upside down
(do not turn the slide over). Mark a sequential number
in the upper right corner of each slide (this will be
extremely useful if the slides ever become mixed).
Use a felt tip marker, rather than labels that will be
loosened by the heat.
3. Make sure that the bottom metal plate on the slide tray
is indexed into the zero position (the plate will not
rotate with respect to the top tray). Remove the top
lock ring by rotating it counterclockwise.
4. Insert slide #1 into slot #1. The number written on the
upper right corner of each slide should be at the top
and facing the next higher numbered slot. Load all
slides and replace and lock the top lock ring.
1. Center the tray over the post on the projector.
2. Gently rotate the tray until the #0 slide slot is at the
index mark and the tray will drop into position. If the
tray does not drop into position, check to see that the
lower metal plate is locked in the zero position (rotate
until it locks).
Advertisement
