Ops Panel - IBM 1269-3S2 Installation, Service And User Manual

IBM System Storage DCS9900 1269-3S2 Storage Expansion Unit Installation, Service, and User Guide

4.3.2 Ops Panel

The Ops Panel displays the aggregated status of all the modules. The Ops Panel LEDs are shown in
Figure 4–2
Note The Ops Panel is supplied as an integral part of the Enclosure core product and is not user replaceable.
Figure 4–2
Table 4–2
Ops Panel LEDs
On
On
On
On
On
On
On
On
On
36
and defined in Table 4–2.
Ops Panel
Ops Panel LEDs
Other Associated LEDs
Off Off
On On Single beep, then double beep Ops panel power on (5s) test state
On Off PSU LEDs or Fan LEDs
intermittent audible alarm
On Flash intermittent audible alarm
Off On LED on EM
Off On LED on EM
Off On None
Flash Flash PSU removed
Flash On intermittent audible alarm
or Alarms
Power On, enclosure ready
Any PSU fault or Fan fault
Over or under temperature
Processor on EBOD Module A failed
Processor on EBOD Module B failed
Unknown (invalid or mixed) module type
installed, or 12C bus failed
PSU removed and system power redundancy
check option set. no indication if option not set.
Ops to EBOD Module communications failed
State Description