Advertisement
I Installing the Image Controller Board
4048U006AB
4508U004AA
4508U005AA
4508U006AA
1. Remove the Rear Cover. (nine screws)
2. Connect the Image Controller Board to the
Control Board (PWB-C/C).
3. Using the four screws furnished with the
Image Controller, secure the Image
Controller Board in position.
4. Disconnect the hookup harness connector of
the Control Board (PWB-C/C).
IC-205
P303
4508U007AA
4048U006AB
– 2 –
5. Connect the hookup harness connector,
which has been disconnected, to the
connector (P303) of the Image Controller
Board.
6. Reinstall the Rear Cover. (nine screws)
NOTE
Use the screw with washer to the position
indicated by the arrow.
Advertisement
