NEC IW77 Assembly Instructions Manual page 6

IWSTAND Assembly Instructions
Whiteboard Attachment
After both legs are attached to frame, place
into the upright position.
The upper sliding frame has two release pins
( Detail B ) for height adjustment. Two peo-
ple are required to make any height adjust-
ments.
There are three different heights available.
The lowest hole on the frame is to be used
when moving the Whiteboard.
To raise frame, grasp the horizontal rail ( 6 ),
pull out release pin, and lift up to the desired
height. Release pin when you have reached
the desired height. Pin will drop into hole.
WARNING
To reduce the risk associated with muscle strain:
•
Always use more than one person when installing
or removing the Whiteboard
You are now ready to attach the Whiteboard.
With one person holding each side of the
board, carefully lift it into position so that the
bracket lip is above the hanger bracket on the
stand. Now lower onto the stand hanger
bracket. Make sure that the board is securely
in place before releasing
( Detail C ).
Locate the two "U" shaped brackets (10)
supplied with the NEC Whiteboard. Looking
at the underside of the bottom rail locate the
small Philips head machine screw, remove it
and (13) install bracket to the bottom edge
with the "circle" opening facing the front of
the board. Repeat for the other bracket.
6 © NEC Display Solutions of America. All Rights Reserved, 2007.
Detail B
Detail C
10
13