Introduction; Purpose Of This Manual; Warnings; Abbreviations, Acronyms, Definitions - Electrolux OVC3000 Service Manual

1 - INTRODUCTION

1.1 - PURPOSE OF THIS MANUAL

The purpose of this Manual is to provide information of new Ovens Power board OVC3000.

1.2 - WARNINGS






1.3 - ABBREVIATIONS, ACRONYMS, DEFINITIONS

AD Analogical Digital
APD All Pole Disconnection relay
FP Food Probe
FPM Food Probe Module
HC Hob controller power board
HUI Hob User Interface
HXOUI Hexagon Oven User Interface
HXPM Hexagon Power module
OC Oven controller power board
OVF Oven Function
OUI Oven User Interface
PWM Pulse width modulation
SB Smart Board
SPD Single pole disconnection relay
SPI Serial Peripheral Interface
ToD Time of day (or OFF_STATE, depends on OUI)
"Vision Control Updated" (OUI type)
VCU
Technical Support - BSP
All work with open appliances must be done with the mains supply
disconnected.
The intervention on electrical equipment should only be performed by
qualified personnel.
Before an operation in a device, check the efficiency of the system housing
through means of appropriate equipment. As an example, refer to the
indications described / illustrated in the portal Electrolux Learning Gateway
(http://electrolux.edvantage.net).
After intervention, verify that the conditions have been restored to the
safety switch apparatus, as just leaving the assembly line.
In the case of manipulation / replacement of the PCB, use the ESD kit (Code
405 50 63-95/4) to prevent electrostatic discharge damage the circuit board
see SB No. 599 72 08-09
5/47 599 73 09-98 Rev. 02