Electrolux OVC3000 Service Manual page 33

DISPLAY
CODE
F214 Configuration compatibility alarm (OUI):
Compatibility of firmware and EEPROM does not match.
OUI shows error message F214 (F14) permanently.
F215 Configuration coherent alarm (OUI):
If an entry of the configuration is out of normal range the
system goes to alarm.
The OUI display an error code F215 (F15).
F716 Pyro hob alarm (OUI):
It is necessary to ensure that a maximum temperature is not
exceeded during a pyrolytic cleaning of a freestanding cooker
M2. Therefore, it is necessary to shut down the hob when a
pyrolytic cleaning is running.
F917 Hob-Oven power management alarm (OUI):
This alarm is only possible in systems where a power
management between oven and hob is implemented.
By power management the oven user interface (OUI) has to
receive the Hob interface Power Status message from the
hob user interface (HUI) before switching on an oven function
(OVF). If the HUI Power Status message is wrong or missing
for 20sec. the oven user interface (OUI) doesn't start the
oven function (OVF), goes into Standby state and shows
F917 (F17).
If an oven function (OVF) is running the oven user interface
(OUI) sends the available power for the hob (with
AVAILABLE HUI_POWER message) every 10sec. If the
answer from the hob user interface (HUI), Power Status
message is wrong the oven user interface (OUI) sends
immediately an Oven function (OVF) without heating
elements to the power board (OC) and wait 20sec. After that
the oven user interface (OUI) goes into Standby state and
shows F917 (F17).
If the hob user interface (HUI) Power Status message is
missing for 20sec. the oven user interface (OUI) has to
switch off the oven function (OVF), goes into Standby state
and shows F917 (F17). The code F917 is reset by the main
switch.
Technical Support - BSP
DESCRIPTION
33/47
TROUBLESHOOTING
User Interface (OUI)fault.
1. Check the compatibility of
the user interface. User
interface probably wrong.
2. User Interface (OUI) fault.
In the freestanding cooker with
electronic control in the hob, it
is necessary to shut down the
hob when a pyrolytic cleaning
is running.
1. Wiring connection between
Hob user interface (HUI) and
Oven user interface (OUI).
2. Hob User Interface (HUI)
fault.
3. Oven User Interface (OUI)
fault.
4. Power board (OC) fault.
599 73 09-98 Rev. 02