Husqvarna R 318X Operator's Manual page 85

Push the switch (A) to make the high beam lights come
on or go off.
A
When the work lights and the rear lights are on, the
headlight symbol (B) shows on the display. When the
high beam lights are on, the filled headlight symbol (C)
shows on the display.
B
Hour meter
The product has 2 hour meters on the display. The hour
meters show how many hours of operation of the engine
has in total (A) and during the operation period (B).
The last digit of the hour meter for the operation period,
shows tenth of an hour (6 minutes).
The time with ignition on but engine off, is not registered.
Note:
The total hour meter (A) only shows full hours.
Note:
A operation period is the time the engine been
turned on during 1 day. A new operation period starts if
the engine is turned off for a minimum of 6 h.
838 - 010 - 15.03.2022
A
Operator Presence Control (OPC)
The OPC engages when the operator lifts from the seat.
The engine and the drive to the blades stop if the blades
are engaged or the parking brake is not applied. Refer to
Start conditions on page 90 .
Forward and rearward pedals
The speed is gradually adjusted with 2 pedals. The left
pedal (A) is used to move forward, and the right pedal
(B) is used to move rearward. The product stops when
the pedals are released.
C
Cutting deck
The cutting decks for this product are Combi cutting
decks with BioClip. BioClip cuts the grass into fertilizer.
The Combi cutting decks can also be used without
BioClip. Without BioClip the grass is ejected to the rear.
B
A
B
85