LifeSource Premier Series Owner's Manual page 19

Setting Timer
To reset the weekly automatic self-cleaning timer [See Figure 12]
• Facing the LifeSource system, loosen
the black nuts on both sides of the timer
head and remove the black cover.
• Look on the right side of the timer face.
Check if the white arrow points at the
correct time of day (A).
• If time is incorrect, press and hold down
the red button (B).
• Turn the large gear (C) until the white
arrow is pointed at the correct time of
day.
• Release the red button.
• The system will now automatically start
the self-cleaning cycle at approximately
2:00 a.m.
• Replace the black cover and tighten the black nuts.
After a power outage, check the timer and set to the correct time of day.
To determine if the timer has power, lightly place your finger on the gray clock
located on the back of the timer face. If the clock is warm, it is receiving power.
Changing Self-Cleaning Cycle
If you would like self-cleaning to occur at a different time, you must adjust the time
of day. For example, if you would like self-cleaning to occur at 12:00 a.m. (two hours
earlier than programmed), you must set the clock two hours ahead of the actual
time. Adjusting the clock to read two hours later than the actual time tricks the
automatic rinse cycle into thinking it is 2:00 a.m. when it is only 12:00 a.m.
See video instructions at
Figure 12 - Premier 2250SE timer
LifeSourceWater.com
17