Advertisement
Available languages
Available languages
3
Attach Tent to Frame
Using Frame Clips
– Attach frame clips along
the edges of tent to frame poles.
(illus. 5), (illus. 6)
– Make any adjustments to the tent
corner stakes that are needed.
Attach Rainfly
4
– Assemble rainfly pole by interlocking
shock-corded pole.
– Insert rainfly pole into reinforced
pockets located at the center edges
of the underside of rainfly. (illus. 7 & 8)
– Tie underside of rainfly to the rainfly
pole with frame ties. (illus. 8)
– Drape rainfly over tent frame, pole side
down. Rainfly pole should point out
over front and back doors of tent.
– Connect the four elastic loops with
"S" hooks, (found at the rainfly
corners) to the four rings located at
the end of the stake loops at the
corners of the tent. (illus 8 & 9)
– Secure rainfly with tent frame ties
located on underside of fly. (illus. 8)
– Extend out front & rear vestibules and
stake out.
– Stake out four tent guylines found at
the corners of the rainfly. (illus. 8)
– Stake out two side guylines found on
the sides of the rainfly.
– Gear loft attaches inside tent with
toggle & loop closures.
Things You Should Know
•
Under certain conditions (cold weather, high humidity, etc.)
condensation will form on the inside surfaces of your tent. Condensation is
caused by water vapor from your breath, perspiration, or any wet clothing
inside your tent. It is NOT LEAKAGE through the tent fabric. It can be
minimized by removing wet clothing from your tent and by providing good
ventilation through the tent.
•
Never store tent, even for a short period of time, without drying it
thoroughly and brushing off caked dirt. Do not pack stakes or poles inside
your tent. Use a separate storage bag.
•
STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF.
NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO
REMOVE STAKE.
•
TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•
Seam sealer has not been provided with your tent. For additional protection
we recommend seam sealing your tent prior to camping. Seam sealer may be
purchased through your local retailer or at your local sporting goods store.
PRINTED IN CHINA
REV. 11/05
illus. 5
Frame clips
Assembled tent without rainfly.
illus. 7
Insert rainfly
pole piece into pocket
on underside of rainfly
illus. 8
Vestibule doors
may be rolled
up and secured
with toggle &
loops for added
ventilation
illus. 9
Completed tent with rainfly
and extended vestibule.
•
Do not leave your tent set-up for weeks at a time, be aware that
exposure to the ultraviolet rays of the sun can seriously damage nylon
material and/or cause it to become discolored.
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the
flammability requirements of CPAI-84. The fabric will burn if left
in continuous contact with any flame source. The application of
any foreign substance to the tent fabric may render the flame-
resistant properties ineffective.
SUNBEAM CORPORATION (CANADA) LIMITED
DOING BUSINESS AS JARDEN CONSUMER
5975 Falbourne Street, Mississauga, Ontario
1-800-387-6161 • www.colemancanada.ca
illus. 6
Rainfly pole in pockets
Tent frame ties
Tie frame ties
to rainfly pole.
"S" hooks attach
rings at the corners
IMPORTED BY
SOLUTIONS
MADE IN CHINA
Guyline
Advertisement
