Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING HEATER TO WALL
Mounting Bracket
Locate mounting bracket in heater carton. Remove
mounting bracket from heater carton.
Figure 6 - Mounting Bracket
Removing Front Panel Of Heater
1. Remove the four painted screws, two on each
side of front panel.
2. Pull bottom of front panel forward, then out.
3. Remove any remaining packaging materials.
16"
Min.
Front Panel
Only Insert Mounting
Screws Through Last
Figure 7 - Removing Front Panel Of
Methods For Attaching Mounting Bracket
To Wall
Only use last hole on each end of mounting bracket
to attach bracket to wall. These two holes are 14"
apart from their centers. Attach mounting bracket
to wall in one of two ways:
1. Attaching to wall stud
2. Attaching to wall anchor
Attaching to Wall Stud:
strongest hold. Insert mounting screws through
mounting bracket and into wall studs.
Attaching to Wall Anchor:
to attach mounting bracket to hollow walls (wall
areas between studs) or to solid walls (concrete
or masonry).
Decide which method better suits your needs.
Either method will provide a secure hold for the
mounting bracket.
113052-01F
14"
Hole On Each End
Floor
Heater
This method provides the
This method allows you
www.desatech.com
Marking Screw Locations
1. Tape mounting bracket to wall where heater
will be located. Make sure mounting bracket
is level.
WARNING: Maintain mini-
mum clearances shown in Figure
8. If you can, provide greater
clearances from floor and join-
ing wall.
2. Mark screw locations on wall (see Figure 8).
Note: Only mark last hole on each end of
mounting bracket. Insert mounting screws
through these holes only.
3. Remove tape and mounting bracket from wall.
Screw
25
/
"
3
4
Optional
19
/
"
3
4
Min.
Figure 8 - Mounting Bracket Clearances
Attaching Mounting Bracket To Wall
Note: Wall anchors, mounting screws and spacers
are in hardware package. The hardware package
is provided with heater.
12"
14"
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
3 Plaque Heater
16"
14"
Min.
Only Insert Mounting
Screws Through Last
Hole On Each End
Floor
4 and 5 Plaque Heaters
25
/
"
3
4
Optional
19
/
"
3
4
Min.
25
/
"
3
4
Optional
19
/
"
3
4
Min.
1
M
Advertisement
Table of Contents
