NAD T761 Owner's Manual page 23

Press the TEST button again to leave or cancel the
Test mode, any changes will be memorized automati-
cally.
The loudspeaker levels can also be individually
adjusted with the OSD setup menu:
• Call up the SETUP menu of the On Screen
Display.
Select the channel for which you wish to adjust and
set the level so that it matches the other speakers.
For best results it is best to start with the Left channel
set at 0dB and to match the other speakers to it.
Normally, if the Right speaker is located at the same
distance from the listening position to the Left speak-
er it should be set at the same level as the Left
speaker.
NOTE:
If no level adjustments were made, press TEST
again to return to the selected source. Any changes
in the Channel Balance Setting, under the test mode,
will be memorized automatically.
LFE (Low Frequency Effects, with a Dolby Digital
source, the subwoofer channel) can be set from
+10dB to -10dB.
The Delay time for the Surround speakers also
needs to be correctly set for your normal listening
position. Refer to the section "Channel Delay" in this
chapter for more information.
GB
NAD
23