Table of Contents
Advertisement
Installation
10. Attach the stepping motor with the two screws (PS3 x 6).
11. Install the SU-167 board with the two solders.
12. Connect the harness to the connector (CN001) on the SU-167 board.
13. Attach the DC motor with the two screws (PS3 x 4).
n
When replacing the DC motor, it is required to apply grease.
. Grease:
. Grease applying portion: Worm gear of DC motor
14. Hook the timing belt on the pulley of the stepping motor. Then, insert the idler pulley shaft into the
hole [A] and insert the worm wheel shaft into the hole [B].
15. Attach the motor block assembly with the four screws (BVTT2.6 x 5).
16. Attach the helical extension spring of the tension arm assembly.
3-26 (E)
7-640-005-36 (SANKOL FG87HSR)
UP-D898DC
Advertisement
Table of Contents
