Table of Contents
Advertisement
Using The Battery Pack
Perform steps 2 – 3 in "Charging The Battery
Pack" (
pg. 12).
Maximum continuous recording time
LCD monitor
Battery pack
on
BN-VF808U*
1 hr. 50 min.
BN-VF815U
3 hrs. 40 min.
BN-VF823U
5 hrs. 30 min.
* Provided
NOTES:
● Recording time is reduced significantly under
the following conditions:
• Zoom or Record-Standby mode is engaged
repeatedly.
• The LCD monitor is used repeatedly.
• The playback mode is engaged repeatedly.
● Before extended use, it is recommended that
you prepare enough battery packs to cover
3 times the planned shooting time.
ATTENTION:
Before detaching the power source, make sure
that the camcorder's power is turned off. Failure to
do so can result in a camcorder malfunction.
Data Battery System
You can check the remaining battery power
and the recordable time.
When the battery is attached, press DATA.
BATTERY CONDITION
LEVEL
100%
50
0
● When the Power Switch is set to "OFF", it is
displayed for approx. 3 seconds if the button
is pressed and released quickly, and for
approx. 15 seconds if the button is pressed
and hold for several seconds.
● When the Power Switch is set to "PLAY" or
"REC", press DATA again to return to the
normal screen.
● Data battery status cannot be displayed
during playback or while recording is in
progress.
Viewfinder on
2 hrs. 15 min.
4 hrs. 30 min.
6 hrs. 45 min.
MAX TIME
LCD
110min
FINDER
135min
GETTING STARTED
● If "COMMUNICATION ERROR" appears
instead of the battery status even though you
tried to press DATA several times, there may
be a problem with your battery. In such a
case, consult your nearest JVC dealer.
Using AC Power
Perform step 4 in "Charging The Battery Pack"
(
pg. 12).
NOTE:
The provided AC Adapter features automatic
voltage selection in the AC range from 110 V to
240 V.
INFORMATION:
The following explanations in this manual
supposes the use of LCD monitor in your
operation. If you want to use the viewfinder,
close the LCD monitor and pull out the
viewfinder fully.
Language Settings
The language on the display can be changed.
(
pg. 24)
1
Select
2
SET
1
Open the LCD monitor fully.
2
Set the Power Switch to "REC" or "PLAY"
while pressing down the Lock Button located
on the switch.
M
● If set to "REC", the recording mode should be
"
"
set to
(
pg. 18).
3
Press MENU.
4
Select "SYSTEM", press SET or
5
Select "LANGUAGE", press SET or
6
Select the desired language, press SET or
.
2
7
Press MENU.
Press 1 whenever you want to return to the
previous menu screen.
13
EN
LANGUAGE
ENGLISH
.
2
.
2
Advertisement
Table of Contents
