Advertisement
1:Stand installation
Left
Right
Stand legs
(each for left and right)
(1) First,install beams to stand legs, hex screws(8) and hex key be used.
(2) Second,install beam cover onto beams, phillip screws(4) and phillip screwdriver be used.
(3) Finally, Put machine on floor stand, hex screws(4) and hex key be used.
Note: please check labels on machine and stand, to ensure correct direction and positon.
The feet of the machine are movable.As shown,turn left and the wheels will be lifted,
the feet are fixed. Turn right, the feet are lifted, and the wheels can move.
Left
(1)
M6 Hex screws x 8
2:Air Pump installation
Air pump
Transfer tube
(1) First,connect "Transfer tube" into "Air pump" and tighten it.
(2) Second, connect "Relief value" into "Transfer tube (on the top)" and tighten it; connect "Silencer" into " Air pump"
and tighten it.
(3) Finally, Connect "Transfer hose" into "Transfer tube(on the right) and tighten it; connect "Transfer hose" to machine
and tighten it.
Note: The transfer hose need to be passed through beam cover.
(1)
Beams
Left
(2)
M4 Phillip screws x4
The screw pattern of the silencer is very sharp.
!
Wear gloves when installing to prevent scratches.
caution
Relief value
Silencer
(2)
M6 Hex screws
Beam cover
Hex Key
(3)
M6 Hex screws x 4
Transfer hose
(3)
M4 Phillip screws
Phillip Screwdriver
The blue tube is for easy installation
of the transfer hose. When installing,
please unscrew the blue tube
Advertisement
