Page 1
H3C WBC580 G2 Multiservice Access Controller Installation Quick Start-AW100 Installation tools IMPORTANT: • No installation tools are provided with the device. Prepare tools yourself as required. • Before you install the device, wear an ESD wrist strap and make sure the strap makes good skin contact and is reliably grounded.
Page 2
CAUTION: Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open the chassis, contact local sales agent for permission. Otherwise, H3C shall not be liable for any consequence. To mount the device in a rack:...
Page 3
Install the cage nuts in the square holes in each rack post. Figure4-1 Installing cage nuts Use M6 countersunk screws and M6 pan-head screws to attach the slide rails to the front and rear sides of the rack posts, respectively. Figure4-2 Installing slide rails...
Use both hands to place the device on the slide rails and slide the device along the slide rails until the mounting brackets on the device touch the front rack posts. Use a Phillips screwdriver to fasten the captive screws in the mounting brackets to secure the device to the rack. After you slide the device into the rack, make sure the bottom edge of the slide rails is in close contact with the device bottom.