MT64DSU Owner's Manual
DIP Switch Settings
The MultiDSU64K printed circuit board contains one 12-position
DIP-Switch block and one 4-position DIP-Switch block as shown in
Figure 2-2. They are located on the side of the circuit board, and are
accessible through the side of the chassis. Each individual switch is
numbered, and can be in either an up (OPEN) or down (CLOSED)
position.
Figure 2-2. MultiDSU64K PC Circuit Board
The MultiDSU64K is shipped from the factory with the configuration
DIP-Switches set to the most common settings. The factory default
settings are:
• 56 Kbps Data Rate Enabled
• DDS Clocking
• RTS Forced On
• Synchronous Mode On
• Test Pattern Disabled
• Loopback Tests Disabled
• Elastic Store Disabled
• 4-Wire and Dedicated Line Operation Enabled
16