How To Use Hayes Compatible Packet Data Mode - Motorola iM1000 User Manual

How to Use Hayes Compatible Packet Data
Mode
To use iX1000 data modem in the Hayes Compatible Packet Data mode
(circuit data AT command interface and packet data over the air), the user
has to carry out the following steps:
To check steps 2-7, use Hyper terminal (AT
Command)
1. Use modem wireless data software to initialize the packet data
parameters (IP address etc.) in your modem and set-up Hayes
compatible profile (see "To configure Hayes compatible profile" on
page 31".
2. Load Hayes compatible user profile (use "ATZ number" AT command,
where number can be 0, 1, or 2
This command causes the modem to set all parameters and
S-registers to the Hayes compatible packet data mode.
3. To instruct the DCE to originate a call, send
ATD <IP_address>..<port _number> or
ATD <IP_address>,,<port_number>
<IP_Address> format is number.number.number.number or
number,number,number,number, where 1<number<255
<port _number > is optional, where 1<port_number< 65535
4. The DCE will respond (like in circuit data) "Connect <baud rate>"
5. Continue to work. Transmit and receive data from the other side.
6. To disconnect and get to command mode type +++.
7. After the "OK" type ATH to hangup.
To check that the right profile is used, use
AT+WS45 and AT+WS46 :
Query : AT+WS45?
Answer : 0
Query : AT+WS46?
Answer : 24
Data Information
N O T E
)
N O T E
57