Asus TUF GAMING H770-PRO WIFI Manual page 17

• Reset button header (RESET)
The 2-pin header allows you to connect the chassis-mounted reset button. Press the
reset button to reboot the system.
• Chassis intrusion header (CHASSIS)
The 2-pin header allows you to connect the chassis-mounted intrusion detection
sensor or switch. The chassis intrusion sensor or switch sends a high-level signal
to the header when a chassis component is removed or replaced, the signal is then
generated as a chassis intrusion event.
17. Thunderbolt™ (USB4
The Thunderbolt™ (USB4
an add-on Thunderbolt™ I/O card that supports Intel
Thunderbolt™ Technology, allowing you to connect
Thunderbolt™-enabled devices to form a daisy chain-
configuration.
• The add-on Thunderbolt™ I/O card and
Thunderbolt™ cables are purchased separately.
• Please visit the official website of your purchased
Thunderbolt card for more details on compatibility.
The add-on card can only be used when installed to the PCIEX16(G4) slot. Ensure to install
your add-on card to the PCIEX16(G4) slot.
18. Q-LEDs
The Q-LEDs check key components (CPU, DRAM, VGA, and booting devices) during the
motherboard booting process. If an error is found, the critical component's LED stays lit up
until the problem is solved.
The Q-LEDs provide the most probable cause of an error code as a starting point for
troubleshooting. The actual cause may vary from case to case.
1.2.2 Rear panel connectors
1
7
TUF GAMING H770-PRO WIFI
) header
®
) header allows you to connect
®
2
8
2
's
®
TB_HEADER
3
9 10
PIN 1
4 5 6
11 12 13
1-7