Table of Contents
Advertisement
System
Picture
Input
Auto Source
Color
Audio
Wide Mode
Pertormance
Hot Key Assignment
OSD
DDC/CI
System
HDMI Black Level
Quick Start Mode
USB Port Select
Save Settings to...
Move
Enter
Picture
USB 3.0
Power-off
Color
USB change
Audio
Pertormance
OSD
System
Save Settings to...
Move
Enter
1.
Press the MENU key to open the OSD.
2.
Toggle the joystick to the up or down to select System from the OSD.Then toggle to the
right to navigate to the element you wish to adjust and press the joystick to enter it.
3.
Toggle to the left or right to adjust the sliding scales.
4.
Input: Select the source
5.
Auto Source: The default is "On", which can support auto search for signal source in
order.
----------------------------------------------------------------------------------------------------------
Note: Surround application must set Auto Source is "Off".
6.
Wide mode: You can select which screen aspect you are using. The options are
Aspect, Full, 1:1 and 21:9.
7.
Hotkey Assigment: Hot Key 1 and Hot Key 2 can't repeat the same function. Hot Key
1 default is (Modes), Hot Key 2 default is (Brightness). Because some functions limit
the Hot Key to be gray out and unavailable. Hot Key can define of: (Modes, Brightness,
Volume, Gamma, Contrast, Low Blue Light, Over Drive).
8.
DDC/CI: Allows the monitor settings to be set through the software on the PC.
-----------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which allows
monitor controls to be sent via software.
9.
HDMI Black level setting.
Mode - Standard
HDMI
On
Full
On
Normal
Off
C-Type
Mode - Standard
Off
Off
from HDMI(2.0) ,DP or DP
X
X
ALT.
Advertisement
Table of Contents
