Download Print this page

Kohler Underscore K-5714-XH2G Manual page 2

5' bubblemassage whirlpool bath

Advertisement

Required Electrical Service
One dedicated circuit required, protected with Class A
Ground-Fault Circuit-Interrupter (GFCI). Outside North America,
this device may be known as a Residual Current Device (RCD).
Blower, Pump:
240 V, 20 A, 50/60 Hz
Technical Information
All product dimensions are nominal.
Installation:
Drop-in, Under-mount
Drain location:
Center
Basin area, bottom:
43" x 25-5/8" (1093 mm x 651 mm)
Basin area, top:
55-9/16" x 28-3/8" (1411 mm x 720 mm)
Weight:
160 lbs (72.6 kg)
Minimum floor load:
53.9 lbs/ft² (263.2 kg/m²)
Water depth:
16-5/16" (415 mm)
Water capacity:
72.017 gal (272.6 L)
Template:
Drop-in, 1268438-7, required, included
Electrical component
Blower: 240 V, 3 A, 50/60 Hz
rating:
Pump: 240 V, 11 A, 50/60 Hz, 1500 W
1-800-4KOHLER (1-800-456-4537)
Kohler Co. reserves the right to make revisions without notice to product specifications.
For the most current Specification Sheet, go to www.kohler.com.
9-7-2019 11:41 - US/CA
Underscore Oval
5' BubbleMassage Whirlpool Bath
Notes
Measure your actual product for rough-in details.
Install this product according to the installation
instructions.
The hot water supply should be 70% of the
capacity of the bath or greater. Installations will
vary.
Kit is required for under-mount installations (sold
separately).
The pump base extends beyond the edge of the
rim. Modify the framing as needed.
IMPORTANT! Dry fit the drain assembly prior to
installing the bath. The bath cannot be installed
with all drain components attached.
If installing a rim-mount faucet, make sure there
is no interference above or below the deck before
drilling any holes.
K-5714-XH2G
4"

Advertisement

loading