Configuring Pitch Bend - Akai Z4 User Manual

62
Chapter 7—Using Programs
Configuring Pitch Bend
Bend wheel operation for Keygroup and Drum Programs can be configured as follows.
Select a Program as explained on page 48, and then press "P-BEND."
1
The Pitch Bend page appears, as shown below.
Select the parameters, and use the JOG dial to set them.
2
Bend Up/Bend Down:
when the bend wheel is moved fully up and down.
Aftertouch:
aftertouch is applied.
Bend Mode:
to "HELD," pitch bend is applied relative to the position of the bend wheel at the time
notes are played. However, note pitch is not affected by subsequent bend wheel move-
ments (i.e., the pitch is held). When set to "NORMAL," the pitch changes as the bend
wheel is moved.
Z4/Z8 User Guide—Version 1.0
(0–24) These determine the maximum amount of pitch bend
(–12 to +12) This determines the maximum amount of pitch bend when
(NORMAL, HELD) This determines how pitch bend is applied. When set