Motorola iDEN i500plus Owner's Manual page 12

PTT Switch Installation
• Connect the PTT switch to the Junction Box (see figure 3, Junction Box
installation).
• Run the cable to the desired location and utilize the Velco
to mount the PTT switch. For manual shift vehicles, the switch is
commonly attached to the gear shift.
USING THE CAR KIT
Your car kit is now installed for use.
PLACING THE PHONE INTO THE PHONE CRADLE
1. Insert the portable phone (lower end first) with battery attached,
into the cradle of the Car Kit, aligning the slots on the lower sides of
the portable with the alignment guides located at the bottom of the
Car Kit cradle.
2. Push the portable phone downward toward the bottom of the cradle,
then push the phone into the cradle, until it "snaps" in place.
3. If the portable phone has been properly installed, the light-emitting
diode (LED), or status light, located at the bottom of the phone cra-
dle will glow when the vehicle's ignition is on.
The display of the portable phone will remain lit whenever the phone is
placed in the Car Kit.
MAKING A DISPATCH CALL - IN PRIVATE AND GROUP
READY MODE
1. Press and hold the PTT button on the remote-mount push-to-talk, or
phone PTT.
2. Speak into the visor microphone to transmit audio.
3. Incoming audio will be heard from the external speaker once the
PTT is released.
MAKING A HANDS-FREE TELEPHONE CALL
1. Use the keypad of the portable phone to place the call.
2. Speak into the visor microphone to transmit audio.
3. Incoming audio will be heard from the external speaker.
12 CAR KIT OWNER'S MANUAL
fastener
TM