Table of Contents
Advertisement
•
If the house has aluminum wiring, follow the procedure below:
1.
Connect a section of solid copper wire to the ends of the flexible conduit
leads.
2.
Connect the aluminum wiring to the added section of copper wire using
special connectors and/or tools designed and UL listed for joining copper
to aluminum.
Follow the electrical connector manufacturer's recommended procedure.
Aluminum/copper connection must conform with local codes and industry
accepted wiring practices.
For power requirements for models JJW3430D and JJW3830D, refer to the
following table.
240 VAC
Model
kW
Install_NW9000K_DG68-00000A_00_EN.indd 9
208 VAC
Amps
kW
Amps
Installation instructions
Prepare built-in oven
1.
Decide on the final location for the oven. Avoid drilling or cutting into house
wiring during installation.
WARNING
Excessive Weight Hazard
Use two or more people to move and install oven.
Failure to do so can result in back or other injury.
2.
To avoid floor damage, set the oven onto cardboard prior to installation. Do
not use handle or any portion of the front frame for lifting.
3.
Remove the shipping materials and tape from the oven.
Remember to keep the packing materials that may be needed for installation.
4.
Remove the hardware package from inside the bag containing literature.
Remove racks and other parts from inside the oven.
5.
6.
Move oven and cardboard close to the oven's final location.
Remove oven door(s)
IMPORTANT: Use two hands to remove oven door. For double ovens, repeat the
process for each door.
1.
2.
A
A
A.
Wire Harness
Prior to removing the oven door,
prepare a surface where you will place
it. This surface should be flat and
covered with a soft blanket, or use
the corner posts from your packaging
material.
Disconnect Wire harness of LED Light
door with Cavity.
English 9
2016-06-30
6:21:38
Advertisement
Table of Contents
