Mitsubishi Heavy Industries FDTC Series Manual

WIRELESS REMOTE
FDTC series (RCN-TC-24W-E2)
CONTROLLER&RECEIVER
Note :
Following functions of FDTC Type-F indoor unit series are not able to be set with this wireless remote control (RCN-TC-24W-E2).
INSTALLATION MANUAL
1. Individual flap control system
Safety precautions
●Please read this manual carefully before starting installation work to install the unit properly.
Every one of the followings is important information to be observed strictly.
WARNING Failure to follow these instructions properly may result in serious consequences
such as death, severe injury, etc.
CAUTION Failure to follow these instructions properly may cause injury or property damage.
It could have serious consequences depending on the circumstances.
●The following pictograms are used in the text.
●Keep this manual at a safe place where you can consult with whenever necessary. Show this manual to installers when
moving or repairing the unit. When the ownership of the unit is transferred, this manual should be given to a new owner.
● Consult your dealer or a professional contractor to install the unit.
Improper installation made on your own may cause electric shocks, fire or dropping of the unit.
● Installation work should be performed properly according to this installation manual.
Improper installation work may result in electric shocks,
● Be sure to use accessories and speci
Use of unspeci
● Install the unit properly to a place with suf
If the place is not strong enough, the unit may drop and cause injury.
● Be sure to have the electrical wiring work done by quali
Power source with insuf
● Shut OFF the main power source before starting electrical work.
Otherwise, it could result in electric shocks, break-down or malfunction.
● Do not modify the unit.
It could cause electric shocks,
● Be sure to turn OFF the power circuit breaker before repairing/inspecting the unit.
Repairing/inspecting the unit with the power circuit breaker turned ON could cause electric shocks or injury.
● Do not install the unit in appropriate environment or where in
generate,
If the unit is used at places where air contains dense oil mist, steam, organic solvent vapor, corrosive gas (ammonium,
sulfuric compound, acid, etc) or where acidic or alkaline solution, special spray, etc. are used, it could cause electric
shocks, break-down, smoke or
● Do not install the unit where water vapor is generated excessively or condensation occurs.
It could cause electric shocks,
● Do not use the unit in a place where it gets wet, such as laundry room.
It could cause electric shocks,
● Do not operate the unit with wet hands.
It could cause electric shocks.
②
Preparation before installation (continued)
To change setting
1. Remove the cover by unscrewing two screws from the back of
receiver.
2. Change the setting by the switch on PCB.
Never do.
fied parts may result in drop,
ficient and improper work can cause electric shock and fire.
fire, or break-down.
flow in, accumulate or leak.
fire as a result of signi ficant deterioration of its performance or corrosion.
fire, or break-down.
fire, or break-down.
Always follow the instructions given.
WARNING
fire or break-down.
fied parts for installation work.
fire or electric shocks.
ficient strength to hold the weight.
fied electrical installer, and use exclusive circuit.
PJA012D791
RCN-TC-24W-E2
PJA012D791
flammable gas could
Master/Slave
setting when
using plural
remote controls
201612
①
Pl
②
Se
PC
1
③
In
①
②
③