Setting By Software; Connecting Equipment - NEC IE-784000-R User Manual

9.2 Setting by Software

9.2.1 Connecting equipment

To set the network information by software, the equipment must be set as follows:
<1> Confirm that the IE-78000-R-SV3 is connected to the setting window.
<2> Connect channel 1 of the IE-784000-R and terminal with the RS-232C cable supplied as an accessory (for the
setting of RS-232C, refer to Table 9-1).
<3> Connect the IE-ETHER cable supplied as an accessory to channel 3 of the IE-784000-R (the other side of the
cable may be left open).
<4> When power is turned on, the menu shown in Fig. 9-1 will be displayed.
IE-SV VX.XX [XX/XX/XX]
--- SETUP NETWORK INFORMATION -------------------------------
1.LOCAL
2.LOCAL
3.LOCAL
4.LOCAL
5.REMOTE ETHERNET ADDRESS
6.REMOTE IP ADDRESS
7.REMOTE HOST NAME
8.REMOTE PORT NO.
9.ROUTER ADDRESS
10.SUBNET ADDRESS MASK
11.EXIT
-------------------------------------------------------------
FUNCTION NO. > XX
CHAPTER 9 SETTING NETWORK INFORMATION
Table 9-1 Setting of RS-232C (factory-set condition)
Baud rate
Character
Parity bit
Stop bit
Modem/terminal
Fig. 9-1 Menu Screen
ETHERNET ADDRESS
IP ADDRESS
HOST NAME
PORT NO.
9600 bps
8 bits
None
2 bits
Modem
XXXXXXXXXXXX
XXXXXXXX
XXXXXXXXXXXXXXXX
XXXX
XXXXXXXXXXXX
XXXXXXXX
XXXXXXXXXXXXXXXX
XXXX
XXXXXXXX
XXXXXXXX
83