Haier HWD80-B14939S8 User Manual page 25

Table of Contents

Advertisement

EN
Problem
Strong vibration while
spinning.
Operation stops
before completing
wash cycle.
Operation stops for
a period of time.
Excessive foam fl oats
drum and/or deter-
gent drawer.
Automatic adjust-
ment of washing time.
Spinning fails.
Unsatisfactory wash-
ing result.
Washing powder
residues are on the
laundry.
Laundry has grey
patches.
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Should the error messages reappear even after the taken measures, switch off the appli-
ance, disconnect the power supply and contact the customer service.
Cause
• Not all transportation bolts have
been removed.
• Appliance has no solid position.
• Machine load is not correct.
• Water or electric failure.
• Appliance displays error code.
• Problem due to load pattern.
• Programme performs soaking cycle.
• Detergent is not a appropriate.
• Excessive use of detergent.
• Washing programme duration will
be adjusted.
• Unbalance of laundry.
• Degree of pollution does not agree
with selected programme.
• Detergent quantitiy was not suf-
fi cient.
• Maximum load has been exceeded. • Reduce loading.
• Laundry was unevenly distributed
in the drum.
• Insoluble particles of detergent can
remain as white spots on the laun-
dry.
• Caused by fats such as oils, creams
or ointments.
9-Troubleshooting
Solution
• Remove all transportation bolts.
• Ensure solid ground and a levelled
position.
• Check load weight and balance.
• Check power and water supply.
• Consider display codes.
• Reduce or adjust load.
• Cancel programme and restart.
• Check detergent recommen-
dations.
• Reduce amount of detergent.
• This is normal and doesn't af-
fect functionality.
• Check machine load and laundry and
run a spinning programme
• Select an other programme.
• Choose the detergent acc. to
the degree of pollution and acc.
to manufaturer specifi cations.
• Loose the laundry.
• Perform extra rinse.
• Try to brush the points from
the dry laundry.
• Choose an other detergent.
• Pretreat the laundry with a
special cleaner.
again.
25

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents