Advertisement
Includes:
2 x walkie-talkies
1 x instruction manual
All packaging materials, such as tape, plastic sheets, wire ties and tags are not part of this toy and should be discarded for your child's safety.
These walkie-talkies operate on 3 x 1.5V LR03/AAA batteries for each walkie-talkie (not included).
Remove the belt clip on the rear of the walkie-talkie will allow you to access the battery door.
To remove the belt clip
It is easier to fit the batteries without the belt clip in place.
Pull the tab forward (away from the handset) to release the belt clip. Then lift the belt clip off.
Installing batteries:
To fit the belt clip
Slide the belt clip down into the slot until it clicks into place.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed from the toy before being charged. Rechargeable batteries are only to be charged under adult supervision. Different types of batteries or new and used batteries are not to be mixed. Only batteries of the same or equivalent type as recommended are to be used. Batteries are to be inserted with the correct polarity. Exhausted batteries are to be removed from the toy. The supply terminals are not to be short circuited. Do not throw batteries into a fire. Remove the batteries if you are not going to use the game for a long period of time. Battery shall not be exposed to excessive heat such as sunshine, fire or the like.
Malfunction or loss of memory may be caused by strong frequency interference or electrostatic discharge. Should any abnormal function occur, remove the batteries and insert them again.
Important safety warning
Switching the walkie-talkies on and off: To turn the walkie-talkies on and off, hold down the on/off button for 2 to 3 seconds. You will hear a musical tone each time to confirm.
Volume control: To adjust the loudspeaker volume, press the ▲ or ▼ button
Changing the channels:
Your walkie-talkie has eight channels, numbered 1 to 8. To communicate with other walkie-talkie users within the range, you must all have your walkie-talkie tuned to the same channel. Press the MENU button once. The current channel number flashes on the display. Press the ▲ or ▼ buttons to go to the channel you want. Press the PTT or MENU button to confirm the channel setting.
Changing the subchannel: If there are many device users near you, there is a chance that some of the users are operating on the same radio channel. When using CTCSS, a low frequency tone (between 67-250Hz) will be transmitted along with the voice signal. Press the MENU button twice, the current CTCSS code will flash on the display. Press the up/down button to choose among the 99 available codes. Press the PTT button to confirm and return to stand-by mode.
Speaking to another walkie-talkie user: Press and hold the PTT button. Walkie-Talkie transmission is 'one way-at-a-time' - while you are speaking, you cannot receive a transmission. Make sure to release the PTT button when you are done talking; this will let your partner communicate back.
Ringtone: You can send ring tone to other handsets within range and tuned to the same channel (and sub-channel if applicable) by short pressing the PTT button. To change the melody, press the MENU button 4 times until "CA" is displayed on the screen. Press the UP▲ or Down ▼ button to choose among 10 available call tones. Press the PTT button to confirm and return to stand-by mode.
Scan (SCAN):
Press and hold during 3 seconds the UP ▲ button: "SCAN" function indicator will appear on the display and the device will scan continuously the channels from 1 to 8. Once an active channel is found, the scanning will stop automatically and you can start transmitting / receiving. Note: If you press PTT button while listening to a found channel, the device will go back to stand-by mode on the found channel.
Hands free function (VOX): Press the MENU button three times, the current VOX setting will flash on the display and the VOX icon will display, Press up ▲ button to set the VOX sensitivity level between 1 and 3 level (level 3 is the high sensitive level).Press down button until "OF" appears on the display to turn VOX OFF. Press the PTT button to confirm and return to stand-by mode. In VOX mode, the radio will transmit a signal when it is activated by your voice or other sound around you. VOX Operation is not recommended if you plan to use your device in a noisy or windy environment. Note: VOX mode will be over ride when you press the PTT button.
Monitor:Press and hold the DOWN ▼ button about 3 seconds to active monitor. Release the DOWN ▼ button return to standby mode.
Roger Beep: Once you released the PTT button, the device will send out a roger beep to confirm that you have stopped talking. Press 5 times the MENU button, "RO" will be displayed. Press the UP▲/Down▼ button to turn on/off roger beep. Press The PTT button to confirm your selection and return to the stand-by mode.
Backlit display:Press any button except for the MENU button to activate the back light of the LCD display. The back light will light on about 5 seconds.
Lock & Unlock the device: Press and hold MENU button for 3 seconds to lock/unlock the device.
Battery saving function: When the device has not been used for 6 seconds, the economy mode is automatically activated. This does not affect the reception of transmission and the standby mode is automatically re-activated as soon as a signal is detected.
Transmitting range
Symptom | Solution |
No power |
|
Weak reception/ no reception/ noisy reception |
|
Cannot change channels |
|
Operating frequencies:
SAR values:
Face: 0.995 W/Kg
Body: 1.410 W/Kg
We, Lexibook® S.A.
6 avenue des Andes
Bâtiment 11
91940 Les Ulis - France
Kind of product: Walkie-Talkies
Type designation: TW48ND
Frequency range: 446.0 - 446.1 MHz
Transmitted power: 26.99 dBm (<500mW)
Hereby, Lexibook Limited declares that the radio equipment type TW48ND is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://www.lexibook.com/doc/tw48/tw48_1.pdf
Yiu Wai Man
Product Development Manager
Hong Kong
Only use a soft, slightly damp cloth to clean the unit. Do not use detergent. Do not to expose the unit to direct sunlight or any other heat source. Do not immerse the unit in water. Do not dismantle or drop the unit. Do not try to twist or bend the unit.
Note: Please keep this instruction manual, it contains important information.
This product is covered by our 2-year warranty.
For any claim under the warranty or after sale service, please contact your distributor and present a valid proof of purchase. Our warranty covers any manufacturing material and workmanship defect, with the exception of any deterioration arising from the nonobservance of the instruction manual or from any careless action implemented on this item (such as dismantling, exposition to heat and humidity, etc.). It is recommended to keep the packaging for any further reference. In a bid to keep improving our services, we could implement modification on the colours and the details of the product shown on the packaging.
Reference: TW48ND
Designed and developed in Europe – Manufactured in China
© Lexibook®T
United Kingdom & Ireland
For after-sales service, please contact us at savcomfr@lexibook.com
This product is not a toy.
Follow us
@LexibookCom
Environmental Protection
Unwanted electrical appliances can be recycled and should not be discarded along with regular household waste! Please actively support the conservation of resources and help protect the environment by returning this appliance to a collection centre (if available).
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the TW48ND that isn't answered in the manual? Leave your question here.