Mounting Wall Mounting Bracket - Worcester Greenstar HIU Installation And Maintenance Instructions Manual

Heat interface unit

Hide thumbs

Table Of Contents

Table of Contents

0010023106-01

Fig. 12 Electric connection

Fig. 13 Vent: HIU and radiator

Fig. 14 Set rotary selector on control unit

Fig. 15 Set room controller, if installed

Greenstar – 6721852556 (2022/11)

5.2

NOTICE

Incorrect assembly can cause material damage.

If the device is assembled incorrectly, it may fall off the wall.

▶ Only install the device on a rigid, solid wall. This wall must be able to

carry the weight of the device and must at least be as large as the

bearing surface of the device.

▶ Only use screws and rawl plugs that are suitable for the wall type and

weight of the device.

The following hole patterns are printed on both sides of the drilling

template:

• Installation on finished wall, wall mounting bracket at top, mounting

plate at bottom.

• Installation on unfinished wall, hole at top for hanging the HIU when

installing cabinet provided by the customer on unfinished wall,

230V

mounting plate at bottom.

▶ Align template with spirit level [1] and attach to wall [2]. Observe the

minimum clearances.

▶ Drill holes for wall mounting bracket [3] and mounting plate

(accessory).

Fig. 16 Drilling template (wall mounting bracket at top), on finished

▶ Attach wall mounting bracket [1] securely to wall. Use appropriate

screws [2] and anchors for this.

Fig. 17 Installing the wall mounting bracket

0010025527-01