Assembly - Craftsman C459-52890 Operator's Manual

NOTE: References to right or left side of the snow thrower are
determined from behind the unit in the operating position.
IMPORTANT: The snow thrower is shipped with oil and WITHOUT
GASOLINE. After assembly, refer to separate engine manual for
proper fuel and engine oil recommendations.
1. Observe the lower area of the snow thrower to be sure both cables
are aligned with roller guides.
a. Pull up and back on upper handle as shown in Figure 1. Align
upper handle with the lower handle.
b. Tighten hand knobs securing upper handle to lower handle.
2. Remove wing nut and hex screw from chute control assembly and
clevis pin and cotter pin from chute support bracket. See Figure 2.
Position the chute assembly (forward-facing) over the chute base.
3. Place the chute control lever in the centered position. See Figure 3.
4. Place chute assembly onto chute base and secure chute control
assembly to chute support bracket with clevis pin and cotter pin
removed earlier. See Figure 4.
5. Finish securing chute control assembly to chute support bracket
with wing nut and hex screw removed earlier. See Figure 5.
6. Check that all cables are properly routed through the cable guide.
See Figure 6.
7. The extension cord is fastened with a cable tie to the rear of the
auger housing for shipping purposes. Cut the cable tie and remove
it before operating the snow thrower.
CAUTION: Prior to operating your snow thrower, refer to Auger
Control Test on page 12. Read and follow all instructions care-
fully, and perform all adjustments to verify your snow thrower is
operating safely and properly.

ASSEMBLY

Figure 1
8
Figure 2
Figure 3
Figure 4