August 2nd, 1995 OVERALL MACHINE INFORMATION SPECIFICATIONS 1. OVERALL MACHINE INFORMATION 1.1. SPECIFICATIONS Paper Capacity: 500 sheets Acceptable Paper Sizes: Model H526 H515 Paper Size Europe Asia Europe Asia Letter Legal Half Letter A5 side- ways F/F4 B5 side- ways Note: The machine does not accept a paper size indicated by a shaded box.
OVERALL MACHINE INFORMATION August 2nd, 1995 COMPONENT LAYOUT 1.2. COMPONENT LAYOUT H110D001.wmf Index Name Description Paper End Sensor This sensor detects when the paper in the cassette has run out. Relay Sensor This sensor detects when the paper is at the exit point of the paper feed unit.
August 2nd, 1995 DETAILED SECTION DESCRIPTIONS PAPER PATH 2. DETAILED SECTION DESCRIPTIONS 2.1. PAPER PATH H110D002.wmf The host fax machine has a paper entrance [A] at the bottom. Paper from the optional paper feed unit(s) comes into the fax machine’s registration area through that entrance.
DETAILED SECTION DESCRIPTIONS August 2nd, 1995 PAPER SIZE DETECTION 2.2. PAPER SIZE DETECTION The machine detects paper size by monitoring the output signals from the three microswitches in the pa- per size sensor [A]. The following table shows the com- binations of the sensor’s output and the paper size detected.
August 2nd, 1995 DETAILED SECTION DESCRIPTIONS PAPER END DETECTION 2.3. PAPER END DETECTION The paper end sensor actuator [A] drops through a slot in the bottom plate when the cassette runs out of paper. The machine then de- tects a paper end condition. H110D006.wmf 2.4.
DETAILED SECTION DESCRIPTIONS August 2nd, 1995 PAPER FEED 2.5. PAPER FEED H110D007.wmf The paper feed motor [A] drives the feed roller [B] and the relay roller [C]. The paper feed clutch [D] turns on when the unit feeds a sheet of paper from the cassette.
August 2nd, 1995 DETAILED SECTION DESCRIPTIONS INTERFACE BOARD 2.6. INTERFACE BOARD (CN6-1) A (CN1-6) Serial Data (Incoming) (CN6-2) +24V (CN6-3) AB (CN1-7) Serial Clock (CN6-4) B (CN6-5) +24V (CN1-9) Latch Signal (CN6-6) BB Paper Feed Motor (CN1-8) Serial Data (Outgoing) (CN5-2) +24V (CN5-2) Clutch On [ 24V]...
Page 10
DETAILED SECTION DESCRIPTIONS August 2nd, 1995 INTERFACE BOARD 1st Paper Feed Unit High High DEF0 = Low CN1-11 DEF1 = Low CN1-12 CN2-2 CN2-1 2nd Paper Feed Unit DEF0 = High CN1-11 DEF1 = Low CN1-12 CN2-2 CN2-1 3rd Paper Feed Station DEF0 = Low High CN1-11...
August 2nd, 1995 INSTALLATION INSTALLATION PROCEDURE 3. INSTALLATION 3.1. INSTALLATION PROCEDURE CAUTION Do the following before installing the optional unit: 1. Print out all messages stored in the memory. 2. Print out the lists of user-programmed items and the system parameter list. 3.
REPLACEMENT AND ADJUSTMENT August 2nd, 1995 4. REPLACEMENT AND ADJUSTMENT 4.1. COVERS H110R001.WMF A: Left Side Cover (3 screws) B: Right Front Cover (2 screws, 1 connector) C: Right Side Cover (2 screws) 4.2. PCB AND PAPER FEED MOTOR h110r002.wmf A: Interface PCB (3 screws, 6 connectors) B: Paper Feed Motor (2 screws, 1 connector) C: Paper Motor Bracket (2 screws)