Graco G3 Instructions page 3

6. Remove reservoir (1) from G3 base. Discard reser-
voir (1) according to local codes for proper disposal.
7. Examine follower plate seal (FPS, F
reservoir seal (LRS) for wear or damage. If it is dam-
aged, it must be replaced. Part No. 175695 is avail-
able from Graco. Contact customer service to order
this part or your local Graco distributor.
F . 4
IG
Reassembly
Always use all of the new parts included in the kit for
reassembly.
1. Install reservoir (1) over the cover/spring/follower
plate assembly (F . 5).
IG
NOTICE
Be careful when installing reservoir that the seal is
not pinched. If the seal is not correctly installed,
grease could leak out of the bottom of the G3 reser-
voir.
1
F . 5
IG
3A6385A
2. Align reservoir assembly on base with vent facing
. 4) and lower
IG
FPS
LRS
rear left
side
F . 6
IG
3. Apply Loctite to bolts (9). Install tie rods (TR)
9/10
F . 7
IG
toward the rear left side of the G3 base.
vent
between the cover (C) and G3 base (B). Install bolts
and washers into the cover and tie rods on the top.
Securely tighten nuts (8) on the bottom of the tie
rods (F . 7).
IG
TR
8
Instructions
C
B
3