Operation - Prem-I-Air EH0527 Manual

Loosen the screws on the base bars. Cross the two bars as shown and align with
the flange. Secure with the four screws, and slider the base cover over the
assembly.
Loosen the clamp screw but do not remove it, then slide the fan assembly down
over the inner tube, and tighten the tube to hold it in place.
Unscrew the plastic nut from the motor housing. Locate the rear guard on the
motor housing - the two holes in the guard align with the two round pegs on the
motor housing. Push the guard firmly into place and secure with the plastic nut.
Insert the motor shaft through the blades, aligning the pin on the motor shaft with
the slot on the back of the blades. Secure the blades in place with the spinner.
Rotate anti-clockwise to tighten - it has a left-handed thread.
Check that the blades are free to rotate.
Attach the logo badge to the front guard using the plastic clip supplied.
Attach the front guard to the rear guard using the clips built into the front guard.
Using a screwdriver, secure the two parts of the guard together with the screw
and nut provided.

Plug the mains lead into a 13 Amp mains socket.

If connecting via an extension lead, make sure that the lead is rated at 3
Amps or more, and that it is fully unwound.

Use the height adjustment knob (see diagram on page 2) to adjust the tube
to the optimum height.

Switch the appliance on at the mains socket.

Use the push-button switches to the speed required:
Low Speed = 3000 m
Medium Speed = 3300 m
High Speed = 3600 m

Oscillation is selected by pressing the oscillation knob downwards (see
diagram on page 2), and switched off by pulling it upwards

It is normal for the motor to become warm in normal use.

Unplug the appliance from the mains when not in use.
At time of going to press, the average cost of electricity is £0.12 per unit (kilowatt-
hour). The amount you are being charged will be shown on your electricity bill. At
this cost, the EH0527 will cost 8p per day to run on the "low speed" setting, 10½p
per day on the medium speed or 13p per day to run on the "high speed" setting.
2592
ASSEMBLY

OPERATION

3
/h airflow
3
/h airflow
3
/h airflow
OPERATING COSTS
3
Ver. 2 - 06/14