Bosch GLM 50 C Professional Original Instructions Manual page 38

OBJ_BUCH-2450-006.book Page 38 Monday, December 18, 2017 12:17 PM
38 | English
Now measure the length L of the second wall.The individual measured value dis-
2
played in the measured-value line d is added to the length L
lengths (displayed in the middle measured-value line d) is multiplied by the saved
height H. The total surface value is displayed in the result line e.
You can measure any number of lengths L
multiplied by the height H.
The requirement for a correct area calculation is that the first measured length (for ex-
ample the ceiling height H) is identical for all sub-areas.
Stake out Function (see figure F)
The stake out function repeatedly measures a defined length (distance). These
lengths can be transferred to a surface, for example to enable material to be cut into
pieces of equal lengths or to install stud walls in a drywall construction. The minimum
adjustable length is 0.1 m, the maximum adjustable length is 50 m.
Note: The distance from the marking is shown in the display in the marking function.
The reference is not the edge of the measuring tool.
Select the stake out function
Set the desired length. Using button 7 [Func] select the corresponding digit/position
and change the value with button 3 [+] or button 8 [–].
Begin the stake out function by pressing the measuring button 2 [
move away from the starting point.
The measuring tool continuously measures the distance to the starting
point. The defined length and the current measured value are thereby
0.81x 0.500m
displayed. The lower or upper arrow displays the shortest distance to
0.483 m
the next or last marking.
Note: The continuous measuring enables you to set a measured value
1
as a defined length by pressing the button 4.
The left factor specifies how many times the defined length has already
been reached. The green arrows on either side of the display indicate
1x 0.500m
the reaching of a length for marking purposes.
0.500 m
Red arrows or red text indicate the actual value when the reference is
outside of the display.
Gradient Measurement/Digital Spirit Level
Select the inclination measurement/digital spirit level
The measuring tool automatically switches between two states.
1 609 92A 48U | (18.12.17)
. The sum of the two
1
, which will be automatically added and
X
.
.
] and slowly
Bosch Power Tools