Microtek ArtixScan 2020 User Manual page 13

8. When the settings are all correct, click OK to
save the modifications. The dialog box should
now show the correct Interrupt Request and
Input/Output address settings. If you're asked
to shut down your computer, select No, then
click Close. You will be asked whether you
wish to restart your computer. Click Yes and
restart your computer.
Resolving situation C
1. Click Start, Settings, and select Control Panel.
2. Double-click Add New Hardware.
3. Click Next and select No for "Do you want
Windows to search for your new hardware?".
4. From the next menu, select SCSI controllers
and click Next.
5. Select Adaptec on the left and "Adaptec AHA-
294X/AIC-78XX PCI SCSI Controller" on the
right. Click Next.
6. In the next menu, make a note of the Input/
Output (I/O) range setting, as well as Interrupt
Request (IRQ) number that Windows
recommends you.
7. When the "Add New Hardware Wizard" dialog
box appears, click Finish.
8. Continue until the installation is completed.
Windows 95 will then ask if you want to shut
down your computer. Select No.
9. Click Start, Settings, and select Control Panel.
10. Double-click on the System icon in Control
Panel and select Device Manager from the top.
11. Double-click on "SCSI controllers" to check
whether conflict happens.
If conflict exists, following the steps of Resolving
Situation B (see page 8) to reset it.
12. When settings are all correct, click OK to save
the modifications. The dialog box should now
show the correct Interrupt Request and Input/
Output address settings. If you're asked to shut
down your computer, select No, then click
Close. You will be asked whether you wish to
restart your computer. Click Yes and restart
your computer.
Resolving situation D
See the section Technical Tips of Installation Guide
that came with your AVA-2903E interface card.
9
Write
this
message
down on
a piece
of paper
for handy
reference.