Pittsburgh 58920 Owner's Manual & Safety Instructions page 4

Operation Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
Removing Tire
CAUTION! TO PREVENT INJURY:
Sharp edges can be left on the
rim. Wear heavy-duty work gloves
and use caution when handling.
CAUTION: To prevent property damage,
failure to use tire mounting lubricant
when removing the tire from the rim
may result in damage to the bead.
1. Remove balancing weights,
if any, from rim edges.
2. Remove tire valve core
to deplete the tire.
3. Place tire rim over Threaded Shaft (13).
See Figure C.
Tire
Asm.
Holder (11)
Figure C
Page 4
Locking Nut (3)
Spacer (2)
Alignment Disc (1)
Threaded Shaft (13)
Base (10)
For technical questions, please call 1-888-866-5797.
4. Install cone end of the
Alignment Disc (1) over
the Threaded Shaft.
5. Place both Spacers (2) over the shaft.
6. Thread the Locking Nut (3) over
the Threaded Shaft and tighten.
7. Attach the end of the Forcing Handle (5)
to the tab of the Locking Nut
using one of the Pins (6).
8. Insert Breaker Handle (4) through
the slot in Forcing Handle and
attach the rubberized Grip (8) to the
Breaker Handle, making sure that
the finger grip end of the handle
is towards the Locking Nut.
9. To break tire beads, Breaker Handle
foot should rest horizontally
over the tire at edge of rim.
(Use combination of adjustment holes
in the Forcing Handle and Breaker
Handle and if required, remove one
of the Spacers). See Figure D.
Grip (8)
Breaker
Handle (4)
Forcing Handle (5)
Figure D
Pin (6)
Item 58920