Mounting Instructions - Pittsburgh 58920 Owner's Manual & Safety Instructions

Mounting Instructions

Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this document including all text under subheadings therein
before set up or use of this product.
1. The Mini Tire-Changer can be mounted
temporarily in a vise (not included)
or permanently to a secure
workbench or surface.
2. For permanent mounting, use
pencil to mark installation holes.
Use mounting hardware (not included)
to mount the Base onto a secure
workbench or stand, making sure
that there are no hidden cables or
wiring below installation surface.
3. Verify that all hardware
(use 7/16" or 1/2" bolts, flat and lock
washers and nuts) is secure and that
base is mounted evenly and is level.
4. Insert Holder (11) into Base and lock
together using the Base Pin (9).
See Figure A.
Base (10)
Base Pin (9)
Figure A
Item 58920
Holder (11)
For technical questions, please call 1-888-866-5797.
5. For temporary mounting to a vise,
position the Base between vise jaws
with the Base Pin accessible from the
sides of the vise. Tighten vise jaws,
Use vise jaw guards to prevent damage
to Holder surfaces. See Figure B.
Holder (11)
Vise
Figure B
Page 3