Blade Guides; Feed Rate - Grizzly G0622 Owner's Manual

Blade Guides

The blade guides should be as close to the
workpiece as possible. This will help ensure
straight cuts by keeping the blade from twisting
and drifting off the cut line.
To adjust the blade guides:
1.
DISCONNECT BANDSAW FROM POWER!
2. Loosen the knob shown in Figure 31 and slide
the blade guide as close to the workpiece as
possible, then re-tighten the knob.
Knob
Figure 31. Blade guides.
-24-
Blade Guides

Feed Rate

The feed rate is controlled by the spring and
handle shown in Figure 32.
To adjust the feed rate:
Slower: Twist the handle clockwise to add ten-
sion to the spring.
Faster: Twist the handle counterclockwise to
remove tension from the spring.
Spring
Figure 32. Feed rate adjustment.
Model G0622 (Mfd. Since 09/17)
Handle