Toro 108-2639 Installation Instruction

Blower Liner Kit
For Z400 and Z500 Twin and Triple Baggers
Model No. 108–2639
Model No. 108–2640
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Step
Blower liner
Fanged elevator bolt
1
Flat washer
Locknut
Step
1
Parts needed for this step:
1 Blower liner
5 Fanged elevator bolt
5 Flat washer
5 Locknut
Procedure
1. Disengage the PTO, set the parking brake, and
chock or block the drive wheels.
2. Turn off the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Remove the five bolts that hold the blower liner
to the blower (Figure 1 andFigure 2). Discard the
hardware.
4. Pull the liner out of the blower (Figure 1).
Note: Do not use your hands to remove the
debris.
5. Remove any debris from the blower.
6. Slide the new liner around the blower impeller.
© 2005—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
Register at www.Toro.com.
Form No. 3353-411 Rev A
Installation Instructions
Qty.
1
5
Replacing the Blower Liner
5
5
The new liner and fanged elevator bolts
may have sharp edges which could cut your
hands or cause slivers. Wear gloves when
handling them.
7. Secure the liner to the rear of the blower with 3
fanged elevator bolts (5/16 x 1 inch), flat washers
and locknuts (5/16 inch) (Figure 1).
Figure 1
1. Blower
2. Liner
3. Fanged elevator bolt, 5/16
x 1 inch
Use
4. Washer, 5/16 inch
5. Locknut, 5/16 inch
Original Instructions (EN)
Printed in the USA.
All Rights Reserved