Stanley FORESITE Mobile Depth Sensor Smart Manual

FORESITE Mobile Depth Sensor Smart Guide
PLACEMENT
Position and Placement
Position the Sensor in the room safely away
from high-traffic areas. The ideal location is
at the foot of the bed to cover as much of the
floor as possible, including the view of both
sides of the bed for Bed Exits.
Extend the pole to the highest possible point
without touching the ceilingor bumping
overhead obstacles.
Plug Unit into Outlet
Unwrap the cord from the
back of the device. Plug the
cord into an outlet.
Ensure the cord is plugged in
behind the device to avoid a
tripping hazard.
ROOM SETUP
1
YOUR TEXT HERE
Tap Setup.
Ready to Set-Up the Mobile
Depth Sensor? Tap Yes.
© STANLEY Healthcare 2021
A
Powering Unit On
If the unit is not already powered
on when positioning and setting up
the unit in a patient room, power-up
the unit by pressing and holding
the power button for 4 seconds.
The Foresite Fall Prevention solution uses artificial
intelligence (AI) to
B
conditions
2
YOUR TEXT HERE
Extend the pole.
Verify Pole Extension.
Tap Done.
Use the Adustable Pole Knob to Loosen
the pole for extension. Tighten the knob when
the pole is extended to desired position.
analyze room and patient
accurate alerts
and issues highly
timely actionable outcomes
YOUR TEXT HERE
Move the sensor back at the bottom
of the bed to capture as much of
Verify the floor is detected
Power
Button
for
3
the floor as possible.
(floor appears blue)
Tap Done.