Baratza Virtuoso+ Operation Manual page 6

®
Note: Partially ground coffee beans may remain between the burrs after the grinder is turned
off. When making ANY grind adjustments, the grinder must be running.
The Virtuoso+ will grind for a predetermined length of time, shown on the display
operate the grinder:
1. Rotate the dial (8) on the display clockwise to increase the grind time in 1.0 second increments, or rotate
counterclockwise to decrease the grind time in 0.1 second increments.
2. The maximum grind time is 40.0 seconds, and the minimum is 0.1 seconds. The timer will loop to 40.0 if adjusted
below 0.1, and will loop to 1.0 if adjusted above 40.0.
3. Press the dial to start grinding. The grinder will automatically stop at 0.0 seconds, or the dial can be pressed
again to pause grinding. To reset the timer once paused, press and hold the dial until the timer is reset, or, after 30
seconds of inactivity, the timer will automatically reset.
PULSE MODE
Note: It is important that if using an espresso basket, hold it below the discharge chute so
that finely ground coffee can fall freely into the basket. Holding the basket too close to the
discharge chute may cause the coffee to back up and clog your grinder.
To grind continuously without the timer, press and hold the dial for 3 seconds to enter pulse mode. "P" will be shown on the
display. The grinder will now grind for as long as the dial is held down, and the timer will count up in seconds as the grinder
is in operation. The maximum grind time is 40.0 seconds in this mode. Rotate the dial more than two clicks to exit pulse
mode.
SLEEP MODE
The grinder will automatically enter sleep mode after 3 minutes of inactivity. The grinder will not draw electrical power in
sleep mode. Rotate or press the dial to wake the grinder. The last value the timer was set to will appear on the display.
December 2022 (v1.4)
VIRTUOSO+ OPERATIONS MANUAL
(7) in seconds. To adjust the timer and
6