Power Sources - Memorex MPD8861PLL User Manual

This CD player requires either two (2) "AA" cell batteries (not included) or
an AC adapter (not included).
BATTERY INSTALLATION
"Low Battery" will appear in the CD display
when the batteries need replacing.
1. Open the CD compartment, then open the
battery compartment door by pressing in on
the tab and then lifting it. To prevent the
possibility of losing the cover, it cannot
be removed.
2. Insert two (2) "AA" cell batteries (not
included) according to the polarity diagram
inside the battery compartment. Alkaline
batteries are recommended for the longest playing time.
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as indicated in the
battery compartment. Reversed batteries may cause damage to the device.
3. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and
Carbon-zinc) or old batteries with fresh ones.
4. If the device is not to be used for a long period of time, remove the batteries to
prevent damage or injury from possible battery leakage.
5. Do not try to recharge batteries not intended to be recharged; they can overheat and
rupture. (Follow battery manufacturer's directions.)
AC OPERATION
To operate the unit using AC power, connect an AC adapter (not included) to
an AC outlet having 120V, 60Hz AC only. Plug the small end into the DC
4.5V jack on the rear of the unit and connect the other end into the AC outlet.
The batteries are automatically disconnected when the AC adapter is used.
CAUTION: When not using AC power, disconnect the AC adapter from
the wall outlet by pulling the plug (not the cord). Do not touch the AC
adapter with wet hands. Fully insert the plug without exposing any part of
the blade.
DC4.5V
z

POWER SOURCES

BATTERY PRECAUTIONS
5