6/16
Assembly description
Table 2: Dummy overview
Subplate
-KP, -VP
Preparation
End plate disassembly
Bosch Rexroth AG, SB23, SB33, EHR23, EHR33, RE 66133-10-R/05.2013
5 Assembly description
5.1 General instructions for the assembly
Generally valid instructions are contained in the basic documentation 66133-01-R.
Disassembly and assembly is described using a control block with dummy block
segments with three tie rods.
The procedure for valves with five tie rods are the same.
EHR valve
-EM2, -EHS1, -EHS2
5.2 Control block disassembly
Tool
• Torque wrench with socket SW13 mm
▶
Disassemble the control block according to the vehicle manufacturer's instruction
and put it down on a clean and stable surface.
▶
Pull the electric plug-in connections.
▶
Separately numerate the control block segments.
1.
Loosen the nuts at the tie rods
and screw them off.
Similarly, for valves with five tie rods the nuts
2.
Pull off the end plate via the tie rods.
SB valve
-M, -EHS1, -EHS2
,
and
by turning them counterclockwise
to
.
End plate
-LS, -EHS