Table of Contents
Advertisement
Information
Electrical Installation Procedure
When installing the appliance, always observe the local regulations and standards.
The appliance is supplied with a moulded power cord. A suitable mains power supply
socket should be available within easy access of the appliance so that it can be
disconnected easily after install.
Plumbing Installation Procedure
• Ensure that the equipment is installed according to local plumbing & water
regulations.
Mains water pressure required (limits): 8 -50psi (50 -1000kPa, 0.05 - 1MPa).
• Fit a stop valve on a cold water line and attach a 9/16-24 UNEF (3/8 Compression
Threads).
• Turn on the water to flush any impurities, dust etc from the inlet hose and water
pipe. Allow several litres through. Especially for new installations.
• Connect the hose to the inlet valve of the appliance.
• Turn on water and check for leaks.
Backflow Prevention
This equipment must be installed with adequate backflow protection to comply with
all applicable federal, state and local codes.
Maintenance
This appliance has been designed to give many years of trouble free service. The
only regular maintenance required is regular wipe down of body and spray head as
well as washing of containers.
5
Advertisement
Table of Contents
