Table of Contents
Advertisement
264
5-6. Using the other interior features
cating that 2-way communication is
enabled.
If the indicators do not flash, perform
3
within the first 10 presses of the Home-
®
Link
button after programming has been
completed.
2
Press a programmed HomeLink
button to operate a garage door.
3
Within 1 minute of pressing the
®
HomeLink
garage door operation has
stopped, press the "Learn" or
"Smart" button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that 2-
way communication is enabled.
Reprogramming a single Home-
■
®
Link
button
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1
With one hand, press and hold the
desired HomeLink
2
When the HomeLink
starts flashing (orange), continue to
hold the HomeLink
perform "Programming Home-
®
Link
"
1
(it takes 20 seconds for
the HomeLink
flashing).
LC500_LC500h_OM_OM11405U_(U)
2
and
®
button, after the
®
button.
®
indicator
®
button and
®
indicator to start
Before programming
■
Install a new battery in the transmitter.
●
●
The battery side of the transmitter must
be pointed away from the HomeLink
Operating HomeLink
Press the appropriate HomeLink
®
button. The HomeLink
should turn on.
The status of the opening and closing
of a garage door is shown by the indi-
cators.
Opening
A
Closing
B
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
refer to www.homelink.com.)
®
.
®
®
indicator light
Advertisement
Table of Contents
