Table of Contents
Advertisement
262
5-6. Using the other interior features
Programming HomeLink
■
1
Steps
through
within 60 seconds, otherwise the indi-
cator light will stop flashing and pro-
gramming will not be able to be
completed.
1
Press and release the HomeLink
button you want to program and
check that the HomeLink
tor light flashes (orange).
2
Point the remote control transmit-
ter for the device at the rear view
mirror, 1 to 3 in. (25 to 75 mm)
from the HomeLink
Keep the HomeLink
view while programming.
3
Program a device.
Programming a device other than
an entry gate (for U.S.A. owners)
Press and hold the handheld transmit-
LC500_LC500h_OM_OM11405U_(U)
®
3
must be performed
®
®
indica-
®
buttons.
®
indicator light in
ter button until the HomeLink
tor light changes from slowly flashing
orange to rapidly flashing green (roll-
ing code) or continuously lit green
(fixed code), then release the button.
Programming an entry gate (for
U.S.A. owners)/Programming a
device in the Canadian market
Press and release the remote control
transmitter button at 2 second inter-
vals, repeatedly, until the HomeLink
indicator light changes from slowly
flashing (orange) to rapidly flashing
(green) (rolling code) or continuously
lit (green) (fixed code).
®
4
Test the HomeLink
pressing the newly programmed
button and observing the indicator
light:
Indicator light illuminates: Program-
ming of a fixed code device has
completed. The garage door or
other device should operate when a
®
HomeLink
button is pressed and
released.
Indicator light flashes rapidly: The
garage door opener motor or other
device is equipped with a rolling
code. To complete programming,
firmly press and hold the Home-
®
Link
button for 2 seconds then
release it.
If the garage door or other device
does not operate, proceed to "Pro-
gramming a rolling code system".
®
indica-
®
operation by
Advertisement
Table of Contents
